Author Topic: Motor Settings for Wanhao Waggster 1.0  (Read 194 times)

Ruomyes

  • Newbie
  • *
  • Posts: 1
    • View Profile
Motor Settings for Wanhao Waggster 1.0
« on: August 15, 2020, 12:01:00 PM »
Hi,

Where can I access the motor settings / E-Axis settings on Waggster firmware for the D9 MK2?


Thanks

CdRsKuLL

  • Administrator
  • Full Member
  • *****
  • Posts: 168
    • View Profile
Re: Motor Settings for Wanhao Waggster 1.0
« Reply #1 on: August 15, 2020, 01:22:24 PM »
you can't do this from the touchscreen but you could write them to a gcode file and run it as a print.  Otherwise you can just compile up a new firmware for the mainboard.  The eeprom is enabled so if you're doing the gcode then make sure you add a M500 to save them.