Author Topic: Artillery SWx1 1.4 with latest waggster FW  (Read 296 times)

blackrazid

  • Newbie
  • *
  • Posts: 1
    • View Profile
Artillery SWx1 1.4 with latest waggster FW
« on: August 14, 2020, 05:31:53 AM »
I have run into a problem or two :)


1. I have an artiellery Sidewinder 1.4, and have added an hemera do it, however when i am to load new filament it feeds the opposite way, (pressing in = it is pushing the filament back out, pressing OUT = pushing filament into the extruder), What could be the cause of this?  I am expecting that i have done something wrong

2. When adding the hemera, i realise that my extruder nozzle is nolonger centred on the printbred, how can i adjust this so that i dont print outside the bed and so on?

Again thanks for the help!


CdRsKuLL

  • Administrator
  • Full Member
  • *****
  • Posts: 168
    • View Profile
Re: Artillery SWx1 1.4 with latest waggster FW
« Reply #1 on: August 15, 2020, 03:04:01 AM »
Hi,

Because of how your new extruder is geared you need to reverse your motor. You can either flip two wires out of the four or change the direction in the firmware. 

If your nozzle is no longer centred then you also need to change your bedsize and offsets.  They are also in the firmware, both are in the configuration.h file from memory.