Author Topic: Artillery X1: plate pieces stick to printed object :(  (Read 43 times)

fededim

  • Newbie
  • *
  • Posts: 2
    • View Profile
Artillery X1: plate pieces stick to printed object :(
« on: October 11, 2020, 10:53:06 AM »
I am attaching 2 pictures, as the title says pieces of the plate stick to printed objects leaving the plate damaged. I have an Artillery X1 v4 with original BLTouch 3.1 and waggster 1.5 firmware. I did 6 prints, 3 without the BL Touch (all fine, plate intact) and 3 with BL Touch (1 fine, 2 damaged the plate). The 3d printed objects have a very strong adhesion to the plate and I have to use a metal spatula several times to pop them off (I have also a plastic spatula and it can't) . The 2 objects which "damaged" the plate where printed with 50% infill, all the others 20%.

Has this happened to anybody else ? I do not know if it is a problem of low quality of the plate of my printer or if it could be a problem with Z offset which maybe is too low (I followed strictly your guide).

Federico