Author Topic: Sidewinder X1 Firmware V1.5  (Read 332 times)

jbrandle1

  • Newbie
  • *
  • Posts: 1
    • View Profile
Sidewinder X1 Firmware V1.5
« on: September 11, 2021, 07:34:24 PM »
One of my prints started to mess up so I stopped it, cleaned the bed and wanted to try again. However when I pressed print then the file I wanted the screen became unresponsive and froze. Seems the only way to make another print was to cycle the power. I also noticed that after a print is complete you cannot print another file as the previous mentioned happens. The only solution is to cycle the power.
Anyone else have this problem?

jimsoar

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Sidewinder X1 Firmware V1.5
« Reply #1 on: September 12, 2021, 03:51:05 AM »
Same sort of thing happening here, installed the mod on a V4 started to print a job cancelled then tried to print again and extruder and bed heated up to temp but no printing