« previous next »
Pages: [1]

Author Topic: Wagster Mod without BLTouch.  (Read 702 times)

Karnivor

  • Newbie
  • *
  • Posts: 1
    • View Profile
Wagster Mod without BLTouch.
« on: February 12, 2021, 03:11:36 PM »
Hi,
First post, thank you for granting me access.

Is it possible to use the Wagster firmware without installing BLTouch. The reason for asking is that I need a reliable firmware that gives me EEprom access and M600. I believe from another thread on here that it is possible by installing a different TFT firmware.
Can anyone help. Ive been trawling the net for days trying to find a suitable solution.
Logged

DocEmmetBrown

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Wagster Mod without BLTouch.
« Reply #1 on: February 17, 2021, 11:54:26 AM »
This is not so easy. If you don't have a Bl Touch installed, then you won't get a Z min when homing the printer. The Z motors would continue to run even though your nozzle is already on the print bed.

This is only possible if you tell the firmware where the pin is with which Z min is switched. I don't know which is the original Z min pin on the motherboard.

Doc
Logged
Pages: [1]
« previous next »