Author Topic: Wanhao D9 leveling hepl  (Read 1075 times)


  • Newbie
  • *
  • Posts: 1
    • View Profile
Wanhao D9 leveling hepl
« on: November 12, 2020, 03:24:49 PM »
Hi all
ive installed the firmware for the d9 ok its just leveling.ive got it where i have the piece of paper under the nozzel to the right hight but when i go to print  its about 5mm off the bed,and to be honest i cant get the auto leveling to work.
could someone give me the idiots guild to leveling please.


  • Administrator
  • Full Member
  • *****
  • Posts: 177
    • View Profile
Re: Wanhao D9 leveling hepl
« Reply #1 on: November 16, 2020, 06:19:51 AM »
You need to adjust your z offset.. have a look at this video.
  so, you will need to keep tapping minus which will bring your head down when printing.. then when you're happy, just restart the print. From then on it will use those settings for all prints you changed and that's it :-)