As mentioned in my first post, I am also new here. If I understand correctly now, I keep the Waggster 1.5 firmware on the board and flash the RAWR TFT on the display, then I have M600 and Waggster BL Touch?
What about the babystep buttons now? Are they still there? Or the Z-Offset key? I need them urgently. It is not always that the Nozzle height is not correct. But now and then I have to correct.
Than i will wait for my ordered Makerbase Wifi module and flash the RAWR-TFT with the rigth Wifi settings.
Can anyone give an answer to this?
Doc
Translated with
www.DeepL.com/Translator (free version)