---

Just a little project I've been working on. Still really need to give it a name, any ideas?

---

So.. I've already done a few upgrades to my CR10s but thought wouldn't it be good to turn it into a Prusa :-)

It will be known as the Creality Prusa  .. :-)

The upgrades I've already done are..
Converted it to a 24v system (PSU, Heated bed and element heater)
Changed the board to a MKS Gen L
Installed some TMC2130 Drivers

Infact you can see everything here..

THIS IS NOT THE FINISHED PRINTER... JUST AS IT CURRENLY IS.. . this is a build log after all :-)



BUT.. now I'm up for a new challenge. I would love to turn my CR10s into a Prusa.. well as close to it as possible.

I'm going to order all the bits today but in short this 'should' do everything the Prusa does except for the XYZ calibration. It will be using the Einsy Rambo board with endless stops, filament sensor, Pinda V2 prob, spring steel bed etc.. It will run on modified Prusa software and have the direct drive full metal extruder. :-)

More details will be added soon.. including a shopping list of where I bought all the items.. wish me luck !   Any questions or comments please post below.

Steve

---

Many thanks to the weekly Prusa crew for choosing one of my designs :-)





It's a small world :-)

Check out their weekly prints at https://www.prusa3d.com/weeklyprints/

If you want to print this or BB9 then you can grab the STL's from https://www.myminifactory.com/object/3d-print-80549

Steve

---

Bit of a video showing two in action..

---

This is a list of parts required to build your own Pretend Prusa...



1. Aluminum frame + front plate + rear plate + Y carriage
2. 3 off U bolts for the bed bearing housing
3. 10 off LM8UU bearings
​4. Smooth rods kit 2 off 320mm + 2 off 330mm + 2 off 370mm
5. Aluminum Profiles kit- 2 off 205MM 3030 + 2 off 120MM 3030
6. 4 off Antivibration Feet
7. 1 off MK52 magnetic heated bed + spring steel bed (textured or PEI)
8. 1 off 30cm sleeve cable for heated bed
9. Motors kit-Nema 17 stepper motor and z axis 320mm motor
10. Einsy board + 1*2004 Reprap Discount LCD screen
11. Filament sensor with cable - Either mk3 or mk3s type
12. Power panic 24v PSU with cable and switch
13. P.I.N.D.A V2 sensor
14. 5v 3 wire 4010 fan (Extruder)
15. 5v 3 wire 5015 fan (Cooling)
16. E3D v6 All metal hotend with 24v heating element and thermistor
17. 50CM Textile Sleeve Cable Wire
18. PTFE Tube cut to 13mm and 50mm (from memory but need to check)
19. BTech drive gear extruder kit
20. 2m gt2 belt with 2* pulley
21. 2off 623h pinion
22. 9off 6mm aluminum spacer for heated bed
​23. Various screw kit
24. PETG for printed parts
25. ABS for cooling part

This list will be continually updated with information