Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - daldridge

Pages: [1]
1
3DUK Firmware / Re: Genius v1.5 crashing beyond the X axis
« on: September 07, 2020, 07:57:57 AM »
I'm in the same boat. I had issues as well. I think most of mine came from setting the Z offset. I found a page that was very helpful in doing that through simple instructions using the terminal of the printer. I'm not sure if I'm supposed to share links here, but this area of the forum isn't very active and I want to help.
https://letsprint3d.net/guide-how-to-calibrate-an-auto-bed-leveling-sensor/

2
3DUK Firmware / Re: Wagster Mod 1.5 for Artillery Genius
« on: September 06, 2020, 01:31:02 AM »
My print looks the same after completing the upgrade. Did you ever find a fix?

Pages: [1]