Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - PnLDesigns

Pages: [1]
3DUK Firmware / Waggster Mod on Sidewinder X1 issue with homing
« on: October 15, 2021, 09:12:24 PM »

I have installed the Waggster Mod on my X1, and every time I use the change filament tool on the tft, or use extrude in octoprint, I always have a failed homing cycle on the next print. It senses that wherever the print head is at, is home, then when it does the probing, it goes off of the right side and errors out. I can prevent this by resetting the printer before printing happens.

Is this a known issue, and is there a fix for it?

Pages: [1]