3DUK

3DUK => 3DUK Firmware => Topic started by: PnLDesigns on October 15, 2021, 09:12:24 PM

Title: Waggster Mod on Sidewinder X1 issue with homing
Post by: PnLDesigns on October 15, 2021, 09:12:24 PM
Hello,

I have installed the Waggster Mod on my X1, and every time I use the change filament tool on the tft, or use extrude in octoprint, I always have a failed homing cycle on the next print. It senses that wherever the print head is at, is home, then when it does the probing, it goes off of the right side and errors out. I can prevent this by resetting the printer before printing happens.

Is this a known issue, and is there a fix for it?